Al‐Fe‐Nd‐B magnets: Where does the Al go? (abstract)

Publication Type

Journal Article

Authors

DOI

Abstract

One successful additive to Fe‐Nd‐B magnets has been Al, which enhances the iHc significantly, even for a 2 at. % (0.8 wt. %) addition. However, in these magnets it is not clear whether Al partitions into the Re2Fe14B phase, the grain boundary phase, or to the interphase interfaces. The main problem, in this case, is the detection of such small quantities in the microstructure. To overcome this “detectability” problem, magnets with 3.9 wt. % of Al have been prepared by the standard sintering route. These magnets exhibit higher iHc compared to the 0.8 wt. % magnet. The results of magnetic, structural, microstructural and microanalytical examination will be reported in this paper. It is hoped that this will clarify unambiguously the question of Al partitioning. © 1988, American Institute of Physics. All rights reserved.

Journal

Journal of Applied Physics

Volume

63

Year of Publication

1988

ISSN

00218979

Notes

cited By 1

Research Areas